RED Compact 24 Betriebsanweisung PDF herunterladen (Seite 28)

2626

6-ELECTRICAL CONNECTIONS6-ELECTRICAL CONNECTIONS

GENERAL PRECAUTIONS

Electrical safety of the system is ensured only when it is properly connected to an ecient earthing system made in compliance with the

safety standards in force: gas, water or heating systems pipes are not suitable as earth connections.

One must check this essential safety requirement; if in doubt, request an accurate inspection of the electrical system to be carried out by

qualied personnel, because the boiler manufacturer is not responsible for any damage caused by failure to earth the system.

Have professionally qualied personnel check the electrical system is suitable for the maximum power absorbed by the heating system,

ensuring in particular that the diameter of cables is appropriate for the power absorbed by the loads.

The use of any component that is powered by electricity entails compliance with some basic rules such as:

• do not touch the appliance with wet and/or damp body parts and/or bare feet;

• do not pull the electric cables;

• do not leave the appliance exposed to weathering (rain, sun, etc.),

• do not allow the appliance to be used by children or inexperienced persons.

230V electrical power supply connection

Installation of the boiler accessory electrical components requires electrical connection to a 230 V – 50 Hz mains: This connection must

be state of the art according to the CEI standards in force.

Hazard!

Electrical installation must be carried out by a qualied technician only.

Before performing connections or any operation on the electrical parts, always disconnect the power supply and

make sure it cannot be accidentally reconnected.

Please note that the boiler electrical power line must be tted with a bipolar switch with a contact gap greater than

3 mm, easy to access, in order to make any maintenance operations quick and safe.

The power cable must be replaced by authorised technical personnel. Failure to comply with the provisions listed above may compromise

the safety of the appliance.

ELECTRICAL CONNECTION

First connect the power cable to the back of the boiler and then to a wall socket.

The main switch placed on the back must only be activated to switch the boiler on; otherwise, it is advisable to keep it switched o.

It is recommended to disconnect the power cable when the boiler is not used.

ELECTRICAL CONNECTION

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 64 65

Keine Kommentare

RED Compact 24 Betriebsanweisung Seite 28