RED DSMC V5.2 Spezifikationen PDF herunterladen (Seite 70)

RED DSMC OPERATION GUIDE

955-0020_V5.2, REV-C | 70

CONTINUOUS RECORD

This is the “normal” recording mode. The camera continuously records frames at the current sensor frame rate.

You can limit each recording to a specific amount of frames using the Limit Recording to setting.

INTERNAL TIMELAPSE TIMER

In this mode, the camera periodically records the specified number of frames at a specified interval. The current

sensor frame rate determines the timing of the frames per pulse.

You can limit each recording to a specific amount of frames using the Limit Recording to setting.

You can also use the Timer Settings to set a specific amount of frames to be captured during an interval of

1–3,599 seconds. When using the Timer Settings, the trigger is the REC key or any key that is programmed to

start recording. The Interval setting specifies the frequency at which the frame or group of frames is captured.

For example, in Internal Timelapse Timer mode, you can choose to record a total amount of 1000 frames, and

take 1 frame every 4.67 seconds. After you’ve recorded 1000 frames (which takes 4,670.00 seconds), the re-

cording process stops.

While recording in this mode, you can see how many frames you’ve recorded out of the total amount of frames

on the overlay.

FRAME TRIGGER

In this mode, the camera records the specified number of frames for each external trigger. This mode limits the

REDCODE based on sustainable record rates.

You can limit each recording to a specific amount of frames using the Limit Recording to setting.

While recording in this mode, you can see how many frames you’ve recorded out of the total amount of frames

on the overlay.

NOTE: There may be a delay between receiving the external trigger and capturing the next frame(s). This delay

may be as long 1 frame period at the current sensor frame rate. To achieve completely synchronized frames to

an external trigger you must set Sensor Sync Mode to MoCo. For more information about setting the Sensor Sync

Mode, go to “GPIO/SYNC” on page 76.

FRAME TRIGGER MODE: PRE AND POST COUNTS

When Frame Trigger mode is enabled, select the number of desired frames for the Pre Count and Post Count:

 Pre Count: The camera captures the frame cache from the time preceding the marker.

 Post Count: The camera captures the remaining frame cache after the marker.

The maximum frame counts are listed in the Available column, and are based on format and REDCODE.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 163 164

Keine Kommentare

RED DSMC V5.2 Spezifikationen Seite 70